Ken J. Jenewein, Attila Kormányos, Julius Knöppel, Karl J. J. Mayrhofer, and Serhiy Cherevko
Abstract
High-impact photoelectrode materials for photoelectrochemical (PEC) water splitting are distinguished by synergistically attaining high photoactivity and stability at the same time. With numerous efforts toward optimizing the activity, the bigger challenge of tailoring the durability of photoelectrodes to meet industrially relevant levels remains. In situ photostability measurements hold great promise in understanding stability-related properties. Although different flow systems coupled to light-emitting diodes were introduced recently to measure time-resolved photocorrosion, none of the measurements were performed under realistic light conditions. In this paper, a photoelectrochemical scanning flow cell connected to an inductively coupled plasma mass spectrometer (PEC-ICP-MS) and equipped with a solar simulator, Air Mass 1.5 G filter, and monochromator was developed. The established system is capable of independently assessing basic PEC metrics, such as photopotential, photocurrent, incident photon to current efficiency (IPCE), and band gap in a high-throughput manner as well as the in situ photocorrosion behavior of photoelectrodes under standardized and realistic light conditions by coupling it to an ICP-MS. Polycrystalline platinum and tungsten trioxide (WO3) were used as model systems to demonstrate the operation under dark and light conditions, respectively. Photocorrosion measurements conducted with the present PEC-ICP-MS setup revealed that WO3 starts dissolving at 0.8 VRHE with the dissolution rate rapidly increasing past 1.2 VRHE, coinciding with the onset of the saturation photocurrent. The most detrimental damage to the photoelectrode is caused when subjecting it to a prolonged high potential hold, e.g., at 1.5 VRHE. By using standardized illumination conditions such as Air Mass 1.5 Global under 1 Sun, the obtained dissolution characteristics are translatable to actual devices under realistic light conditions. The gained insights can then be utilized to advance synthesis and design approaches of novel PEC materials with improved photostability.
